patches_for_osi_client
Differences
This shows you the differences between two versions of the page.
— | patches_for_osi_client [2022/09/03 23:25] (current) – created - external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | [[ http:// | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | __Example step by step for art replacement: | ||
+ | - make copy of UO directory for safety, my copy is named c:\UO_Copy used in following commands | ||
+ | - make a subdirectory named c: | ||
+ | - you need mulpatcher and LegacyMULCL-N in the temp directory from download at above web site | ||
+ | - copy artLegacyMUL.uop | ||
+ | - Temp should look like this {{: | ||
+ | - open a command window | ||
+ | - cd C: | ||
+ | - LegacyMULCL-N.exe -x c: | ||
+ | - Now Temp looks like this {{: | ||
+ | - note you have art.mul and art.idx now .. this is only file type mulpatcher works on | ||
+ | - I apply justnotrees.zip | ||
+ | - move the unzip file ART_justnotrees to the Temp folder | ||
+ | - now Temp folder looks like {{: | ||
+ | - start mulpatcher | ||
+ | - click on settings tab at bottom, sometimes you have to make window bigger to see tabs | ||
+ | - in Art secion (second column top place) click the ... and pick your artidx.mul and art.mul files that you made when you ran LegacyMULCL-N in step 6 {{: | ||
+ | - Click Load and wait a minute while it loads | ||
+ | - click on features tab {{: | ||
+ | - in Autopatch section select justnotreesOSI.txt | ||
+ | - in drop down pick Art (s) | ||
+ | - * Mulpatcher should look like this {{: | ||
+ | - Press start | ||
+ | - * Success will present this {{: | ||
+ | - click OK | ||
+ | - Back to Settings tab {{: | ||
+ | - In that art section you did load in step 12, you now want to do save | ||
+ | - Save back into Temp .. you will probably have to change up 1 directory because the save is going to open in the justnotrees directory {{: | ||
+ | - It will save 2 times, once for Artidx.mul and once for art.mul | ||
+ | - Done with mulpatcher. click close box(edited) | ||
+ | - now have to convert those mul back to uop, but it wont write over your c: | ||
+ | - back to command prompt | ||
+ | - run LegacyMULCL-N.exe .\ in command prompt result will look like {{: | ||
+ | - Now you have a NEW c: | ||
+ | - copy this c: | ||
+ | - Change your RE startup to point to client in UO_Copy .. fill out all the stuff based on your server {{: | ||
+ | |||
+ | **PLAY WITHOUT TREES !!** | ||